?host= 172.21.222.27& ipid=04&port=417940) All my eControls were connecting using IP ID they were compiled with, which was luckily IP ID of the Touch Panel, so they worked, but caused other issues. I discovered that overriding IP ID in the link to eControl stopped working couple of years ago.

Than compile it.įor a while now, I have to specify IP ID and port in VTProe even for web eControl hosted on Fusion. exe, you need to specify the connection settings in VTPro, IP of the processor, IP ID, and port 41794 usually. THE UNIT IS IN VERY GOOD CONDITION AND BARELY USED.The Crestron® RMC3 is a compact and cost-effective 3-Series Control System® designed to provide control and monitoring for a single display device, a small AV system, lighting and shading, climate control, security, energy management, and many other specialized applications. Then, if it's and Web XPanel, and you are using 2 series processor or DMPS3-4K-150, You need to put Core 3 XPanel Web Configuration Module v1.1 (from Crestron Modules Database) anywhere in the Simpl program, or it will not connect. You have to have a XPanel defined in your Simpl program, and have it at the same IP ID as your UI project. Crestron has solutions for each of these affected products in their respective sections below. If you want to upload XPanel to the processor, and use processors web server to host it, make and upload XPanel 2.0 (Web) Smart Graphics. Crestron XiO Cloud Remote Control Crestron Touchscreens (including TSW, TST-902, TS-1542, & TSS Scheduling) Some Crestron devices utilize Smart Graphics Web XPanel and are affected by the Adobe Flash end-of-life.

Rmc3 xpanel